Aztech ADSL2+ Ethernet Router Guide de l'utilisateur télécharger pdf (Page 22)

4.6.1 UPnP

UPnP NAT and Firewall Traversal allow traffic to pass-thru the ADSL Router for applications

using the UPnP protocol. This feature requires one active DSL connection. In presence of

multiple DSL connections, select the one over which the incoming traffic will be present, for

example the default Internet connection.

To enable UPnP, you must first have a WAN connection configured. Once a WAN connection is

configured, click Advanced and under Advanced, select UPnP. This will bring up the screen

shown in Figure 13. You must enable UPnP and then select which connection will utilize UPnP.

In this case the PPPoA connection is enabled.

Figure 13 (Management IP address)

The apply button will temporarily save this connection. To make the change permanent you need

to click on Save Settings (at the side of the page). At the system commands page, click on Save

All.

- 22 -

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Pas de commentaire

Aztech ADSL2+ Ethernet Router Guide de l'utilisateur Page 22