Aztech 56K PCI Modem Manuel d'utilisateur télécharger pdf (Page 17)

TECHNICAL REFERENCE

S-Registers

To change a setting, use the ATSr=n command, where r is the register and n is a decimal value from 0 − 255

(unless otherwise indicated).

S0 0 Sets the number of rings on which to answer in Auto Answer mode. When set to 0, Auto

Answer is disabled.

S1 0 Counts and stores the number of rings from an incoming call. (S0 must be greater than 0.)

S2 43 Stores the ASCII decimal code for the escape code character. Default character is +. A value of

128 – 255 disables the escape code.

S3 13 Stores the ASCII code for the Carriage Return character. Valid range is 0 – 127.

S4 10 Stores the ASCII decimal code for the Line Feed character. Valid range is 0 – 127.

S5 8 Stores the ASCII decimal code for the Backspace character. A value of 128−255 disables the

Backspace key’s delete function.

S6 2 Sets the number of seconds the modem waits before dialling. If Xn is set to X2 or X4, this is the

time-out length if there isn't a dial tone.

S7 60 Sets the number of seconds the modem waits for a carrier.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Pas de commentaire

Aztech 56K PCI Modem Manuel d'utilisateur Page 17