Aztech 56K PCI Modem Manuel d'utilisateur télécharger pdf (Page 18)

TECHNICAL REFERENCE

S8 2 Sets the duration, in seconds, for the pause (,) option in the Dial command.

S9 6 Sets the required duration, in tenths of a second, of the remote modem’s carrier signal before

recognition by the 3Com U.S. Robotics modem.

S10 14 Sets the duration, in tenths of a second, that the modem waits to hang up after loss of carrier.

This guard time allows the modem to distinguish between a line disturbance from a true

disconnect (hang up) by the remote modem.

Note: If you set S10 = 255, the modem will not hang up when carrier is lost. Dropping DTR

hangs up the modem.

S11 70 Sets the duration and spacing, in milliseconds, for tone dialling.

S12 50 Sets the duration, in fiftieths of a second, of the guard time for the escape code sequence (+++).

S13 0 Bit-mapped register. Select the bit(s) you want on and set S13 to the total of the values in the

Value column. For example, ATS13 = 17 enables bit 0 (value is 1) and bit 4 (value is 16).

Bit Value Result

0 1 Reset when DTR drops.

1 2 Reset non-MNP transmit buffer from 1.5K to 128 bytes.*

2 4 Set backspace key to delete.

3 8 On DTR signal, auto dial the number stored in NVRAM at

position 0.

4 16 At power on/reset, auto dial the number stored in NVRAM at position 0.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Pas de commentaire

Aztech 56K PCI Modem Manuel d'utilisateur Page 18