Aztech HomePlug Turbo Manuel d'utilisateur télécharger pdf (Page 17)

User Manual

Page 17 of 42

Step 2

Press Simple Connect for ten seconds from a HomePlug AV Z. After you release the

button, All LED will blink. The Power LED will stay ON.

Note:

If the all LED did not blink, press Simple Connect again for ten seconds.

Step 3

Press Simple Connect Button for two seconds on the existing HomePlug AV device. After

you release the button, the Power LED will continuously blink. If the Power LED did

not blink, press Simple Connect again for two seconds.

Make sure to press Simple Connect Button again on the HomePlug AV Z within two

minutes after you press Simple Connect from the existing network.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Pas de commentaire

Aztech HomePlug Turbo Manuel d'utilisateur Page 17